Beta Test - Hub Led not working

prm3d

I originally set up my Hub and Raspberry Pi configuration using the dedicated power source method and had calibrated a few Kceptors. The way I wired the jumpers originally was according to the vimeo tutorial Juan created. Then after calibrating my 4th Kceptor I decided this time to try unplugging the Kceptor instead of turning the system off. When I unplugged, the cable from the Kceptor to the Hub while it was on with the blue light, the blue light all of the sudden turned off and I am not able to get it working again.
I have attached photos of the cabling of my jumpers after it died and I wired it in the 3v3 rail method.
I have also tried just powering the JP1 Hub with a micro usb wall wart, but that doesn't seem to make it power either.

prm3d

@daylanKifky Above are images of my setup.

daylanKifky

Thanks!
In the photos the black jumper on JP1 is positioned to select the onboard power supply, so even if you connect the 3v3 rail from the RPi you won't get any power.

Before plugging the complete setup et's try the RPi power source alone:

Start with the an unpowered RPi and Hub

Unplug all wire jumpers but the Yellow and Grey ones (3v3 and GND respectively)
Move the black plastic jumper on JP1 to the lowermost position, as in this photo (the same you pasted before on the other thread). As you can see jumper connects the pins #2 and #3 from JP1 leaving the pin #1 unconnected.
Power the raspberry.

At this point the led on the Hub should turn on.

If everything went well you can unplug the raspberry from power, connect all the jumper wires, power the raspberry and try the i2cdetect test

prm3d

daylanKifky EUREKA! It worked! I checked with the i2cdetect test and it posted 73, so I think it is working now.
Thank you so much!

daylanKifky

Great!